⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
technical article
Knowledge of pressure calibrator
2011-8-29 9:22:24

压力打不上去,可能存在的问题以及解决方法 有以下几点 下: The pressure of the pressure calibrator can't catch up. The possible problems and solutions are as follows :
置的 压力软管的快速接头内的“O” 型圈掉了,导致输出不封压力打不上 First, the "O" ring in the quick connector of the pressure hose configured for pressure output is lost, resulting in an unsealed output pressure .

应将密封圈垫上 Solution: Put the seal on the gasket .
Second, the test form was not connected .

     方法: M10*1 堵头在压力输出口处直接堵紧,然后打压对 压力 校验 自身进行密封检查,如果漏 说明校验仪 出现问题 ,如不漏压能加上压,说明被检表没接好 Solution : First plug the M10 * 1 plug directly at the pressure output port, and then press down to check the seal of the pressure calibrator itself. If the pressure leaks, it means that there is a problem with the calibrator. , Indicating that the form under test was not connected .
压力校验仪 是即带正压, 带负压的,可能是正负压切换开关未切换到位 3. If the pressure calibrator has both positive and negative pressure, the positive and negative pressure switch may not be in place .

    校验正压时 切换开关全部拔出,校验负压时应将切换开关按到位 Solution: Pull out the switch when checking the positive pressure, and press the switch in place when checking the negative pressure .
Fourth, the low pressure is okay when the pressure is on. The hand pressure pump will pop out when the pressure is high, and the resistance will be greater .

在造压时手压泵必须推到位,压力 可从单向阀进去, 如果 感觉有种活塞与前相碰撞的感觉 就可以 说明压力泵推到位 Solution: The hand pump must be pushed in place during pressure build-up before the pressure can enter from the one-way valve. If there is a feeling of the piston colliding with the front, it can be said that the pressure pump is pushed in place .
5. The cut-off valve is not locked, and the pressure calibrator cannot maintain the pressure .

     应顺时针锁紧阀门. Solution: The valve should be locked clockwise.