⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
technical article
Introduction of turbine flowmeter
2011-7-11 17:03:23

(1) The material of the turbine flowmeter body is generally 304 stainless steel, and 316 stainless steel can also be selected for corrosion protection. If it is an explosion-proof area, an explosion-proof turbine flowmeter should also be selected.

(2) Turbine flowmeter bearings generally have three specifications of tungsten carbide, polytetrafluoroethylene, and carbon graphite: tungsten carbide has the highest accuracy, which is used as a standard part for industrial control; polytetrafluoroethylene, carbon graphite can be anticorrosive, and is generally used in chemical industry. Place is given priority. The life of the bearing is proportional to the inverse square of the flow rate, so the best flow rate is better than 1/3 of the maximum flow rate.

(3) The turbine flowmeter induction probe detects the motion of the rotating impeller and converts it into a pulsed digital electrical signal. Its electromagnetic coil voltage output value is close to a sine curve. The frequency range of the pulse signal changes linearly with the measured flow rate. Typical The range is 10: 1, 25: 1 and 100: 1. The resistance of the electromagnetic coil is generally less than 2000Ω, and greater than this value may be damaged.