⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
technical article
Maintenance of drop-in level transmitter
2011-8-20 15:49:32

Pay attention to the following points when maintaining the level transmitter :

在使用期间 每个月清洗一次 First, the input level transmitter should be cleaned once a month during use ;
投入式液位变送器 清洗时 ,应先 打开投入式水位仪铁管的旋帽, 小心 的将 液位计拿出 ,然后 将液位计上附着的杂物 全部 清除掉 2. When cleaning the input-type level transmitter , you should first open the screw cap of the iron tube of the input-type level meter , carefully take out the level gauge , and then remove all the debris attached to the level gauge ;
投入式液位变送器 水位计引压孔时,可 三氯乙烯或 酒精注入引压孔 ,注满至它 高度 二分之一处 ,然后 浸泡5 分钟左右, 轻微晃动 ,需要 重复多次,直到清洗干净 止。 3. When cleaning the pressure gauge hole of the water level gauge of the input level transmitter , you can inject trichloroethylene or alcohol into the pressure gauge hole , fill it to a half of its height , and soak it for about 5 minutes, then Slightly shake and need to be repeated several times until it is clean . 使用任何器具清洗引压孔,以 防止 损坏敏感芯子感压膜片; It must be noted that do not use any appliances to clean the pressure hole to prevent damage to the sensitive core pressure sensitive diaphragm;

清洁 投入式液位 变送器 压力接口和引压孔时, 不要使 用硬度过大的刷子或 金属工具,以 防止 损伤敏感芯子 及压力接口螺纹; 4. When cleaning the pressure interface and pressure hole of the input level transmitter , do not use excessively hard brushes or metal tools to prevent damage to the sensitive core and pressure interface threads;

所有 清洗完毕后 倒出的 液位计慢慢放回铁管中,感觉已放 铁管的低部, 然后 将旋帽安装回原处 就可以了 5. After all the cleaning is completed , slowly return the poured liquid level gauge to the iron pipe, feel that it has been placed in the lower part of the iron pipe, and then install the screw cap back to the original position .