⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
technical article
A brief introduction to the installation and maintenance of magnetic level gauge
2011-12-1 9:03:44

计是根据国内外同类产品加以消化提高且按照原化工部颁布的磁性液位计标准研制生产的产品。 The magnetic flap liquid level gauge is a product developed and produced according to the similar products at home and abroad and digested and improved in accordance with the magnetic level gauge standards issued by the former Ministry of Chemical Industry. The instrument can be used in various towers, tanks, tanks, spherical vessels and boilers.

Media level detection.

安装与保养有以下几点: The installation and maintenance of the magnetic flap level gauge have the following points:

1. The level gauge must be installed vertically to ensure that the float assembly can move up and down freely in the main tube.

2. No conductive magnets are allowed near the main body of the level gauge, otherwise it will directly affect the operation of the level gauge F.

3. After the installation of the liquid level gauge, it is necessary to use magnetic steel for calibration to guide the column once to display red below the zero position and white above the zero position.

4. When the liquid level gauge is put into operation, first open the lower pipe valve to allow the liquid medium to enter the main tube smoothly, to avoid the liquid medium from rising rapidly with the floating ball component, which will cause the column to fail and turn over. If this happens, wait for the liquid surface

After stabilization, it can be re-calibrated with magnetic steel.

5. In order to avoid damage to the float assembly during transportation, remove the float assembly from the main tube of the level gauge before leaving the factory. After the level gauge is installed, open the bottom drain flange and reinstall the float assembly Into the main tube

Inside, note that the heavy end of the float assembly is facing up and cannot be inverted. If the floating ball component is installed in the main tube when leaving the factory, in order to ensure that the floating ball component is not damaged during transportation, we use a soft card to fix the floating ball component in the main body.

Inside the body tube, just pull out the soft card during installation.

6. According to the condition of the medium, you can regularly find the sewage flange to clean and clean the sediment on the main pipe.