⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
technical article
Matters needing attention when using the magnetic flap level gauge
2012-12-24 16:35:46

1. The magnetic flap liquid level gauge must be installed vertically, because a ball valve is installed between the magnetic flap liquid level gauge and the container guide tube, which is convenient for maintenance and cleaning; Outlet to prevent material fluid, rapid changes in local areas, affecting the accuracy of liquid level measurement results;


2. The medium should not contain solid impurities or magnetic substances, so as not to cause jams to the float;


3. Before use, the small balls below the zero position should be placed in red with calibration magnetic steel, and the other balls should be white;


4. Open the bottom flange and install the magnetic float (note: the heavy end with magnetic end is up, it cannot be inverted!);


5. When commissioning, first open the upper valve and then slowly open the lower valve to allow the medium to enter the main pipe smoothly. (During the operation, the medium should be prevented from impacting the float quickly, which will cause the float to fluctuate and affect the display accuracy.) Observe the magnetic red and white balls Whether the overturning is normal, then close the lower guide valve and open the drain valve to lower the liquid level in the main pipe. (You can use this method to debug three times and confirm that it is normal!)