⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
Industry Information
Let us know the pressure gauge
2011-12-12 9:04:10

Let me briefly introduce the precautions and installation knowledge of the pressure gauge. Let us first understand the precautions of the pressure gauge as follows:
1.When measuring steam pressure, a condensate pipe should be installed to prevent high-temperature steam from directly contacting the pressure measuring element; for pressure measurement of corrosive media, an isolation tank with a neutral medium should be added.

应安装在易观察和易检修的地方 2.The pressure gauge should be installed in a place where it is easy to observe and maintain.


3. The connection of the pressure gauge should be based on the level of the measured pressure and the nature of the medium. Select a suitable material as the gasket to prevent leakage.

4.The installation site should avoid vibration and high temperature


In short, according to the different properties of the measured medium (high temperature, low temperature, corrosion, dirt, knots, precipitation, thick drilling, etc.); corresponding measures must be taken to prevent heat, corrosion, freezing, and blocking.

的安装知识(测压点的选择) Next, learn about the installation knowledge of pressure gauges (selection of pressure measurement points)

When measuring the pressure of a flowing medium. The pressure taking point should be perpendicular to the flow direction. The inner end of the pressure pipe and the inner wall where the production equipment is connected should be level and free of protrusions or burrs;


It should be selected in the section of the pipe where the measured medium flows in a straight line, and not in the bend, branch, dead angle or other places where vortices are likely to form;


When measuring liquid pressure, the pressure taking point should be in the lower part of the pipeline so that no gas will accumulate in the pressure guiding tube; when measuring gas pressure, the pressure taking point should be above the pipeline so that no liquid will accumulate in the pressure transmitter's pressure guiding tube;

Auxiliary pressure tube

取压口到压力表之间应装有切断阀、以备检修压力表时使用、切断阀应装设在靠近取压口的地方; A shut-off valve should be installed between the pressure take-off port of the pressure transmitter and the pressure gauge for use when servicing the pressure gauge. The shut-off valve should be installed near the take-out port;

The thickness of the pressure guiding tube should be appropriate. Generally, the inner diameter is 6-10 mm, the length should be as short as possible, and the longest should not exceed 50 m to reduce the delay of pressure indication.

When the measured medium is easy to condense or freeze, it is necessary to install a heat tracing pipeline.

The pressure pipe should be installed horizontally with an inclination of 1: 10-1: 20 to facilitate the discharge of the liquid (or gas) stored in it.