⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
Industry Information
Installation method of side-mounted magnetic flap liquid level gauge
2011-9-16 17:35:01

   因此 液位计出厂前,用卡丝将磁性浮子固定在下引液管处,用户在安装使用前应 先抽去卡丝方能安装。 1. In order to prevent the magnetic float from being hit by high-speed movement in the main pipe during transportation , the magnetic float is fixed to the lower drainage tube with a wire before the level gauge leaves the factory. The user should remove the wire before the installation. We can install.

液位计 ,以保证磁性浮子在主导管内上下运动自如。 2. The liquid level gauge must be installed vertically to ensure that the magnetic float moves freely up and down in the main conduit.

装有截止阀,以便清洗和检修时切断物料。 3. A shut-off valve should be installed between the level gauge and the container to cut off the materials during cleaning and maintenance.

可以 有导磁体靠近, 要不然 会直接影响液位计正常工作。 4. There should be no magnets around the cylinder of the level gauge , otherwise it will directly affect the normal operation of the level gauge.

液位计 安装完 成之后 ,需用磁钢进行校正。 5. After the installation of the liquid level gauge , it is necessary to use magnetic steel for calibration. Guide the magnetic flip column once, so that red below the zero position and white above the zero position.

先打开上引液管阀门,然后慢慢开启下引液管阀门,让液体介质平稳地进入主导管,避免液体介质带着浮子急速上升,造成磁翻柱翻转失灵或 翻乱 6. When the liquid level gauge is put into operation, you should first open the upper drainage tube valve, and then slowly open the lower drainage tube valve to allow the liquid medium to enter the main conduit smoothly, so as to avoid the liquid medium from rising rapidly with the float, causing magnetic turnover Failure or disorder of column flipping ;        注意重端带磁性一端向上,不能倒装 7. When opening the bottom flange blind plate and loading the magnetic float, it should be noted that the magnetic end of the heavy end is upward, and it cannot be inverted .

液位计 筒体内不应 有固体杂质和磁杂质进入,以 免对浮子造成卡阻 及减弱浮力。 8. There should be no solid or magnetic impurities in the level gauge barrel to avoid blocking the float and weakening the buoyancy.

定期打开排污阀清洗主导管,清除管内沉积物质。 9. According to the condition of the medium, the drain valve can be opened regularly to clean the main pipe and remove the sediment in the pipe.