⎝⎛星力捕鱼⎞⎠

⎝⎛星力捕鱼⎞⎠ page Company Profile ⎝⎛星力捕鱼⎞⎠ Product center Quality system marketing network After sales service Recruitment contact us
Flow meter series
Temperature instrument series
Pressure instrument series
Calibration instrument series
Level instrument series
Digital display instrument series
Transmitter instrument series
Wire and cable series
Bridge instrument cabinet series
Pipe fitting valve series

Address: Xiongyi, Jinhe Road, Jinhu County, Jiangsu Province
Lunan
Phone: 0517-86900901
0517-86900921
0517-86900920
Fax: 0517-86900902
Postcode: 211600
http://zzyfwh.com
Email: chinadongxiang@163.com
Industry Information
Maintenance points of stainless steel solenoid valve
2011-11-18 10:19:02

   防腐蚀性能良好,电磁部分、密封件全部采用特种耐高温电工材料和密封材料。 The stainless steel solenoid valve has good anti-corrosion performance. All electromagnetic parts and seals are made of special high-temperature resistant electrical materials and sealing materials. Relatively wear-resistant, structure   Simple and easy to use. Use it with great care. A special staff member is required to take care of it, and be responsible for its use and maintenance. 定期清洗大阀内外及衔铁吸合面的污物。 Secondly, the dirt inside and outside the large valve and the armature suction surface must be cleaned regularly. 注意不要损坏密封面。 Take special care not to damage the sealing surfaces. 不锈钢电磁阀较长时间不用时,应关闭阀前手动阀,重新启用时,蒸汽电磁阀应将冷凝水排除干净, 然后试着启动几次, ,开关正常后 投入使用。 When the stainless steel solenoid valve is not used for a long time, the manual valve in front of the valve should be closed. When it is re-enabled, the steam solenoid valve should drain off the condensate, and then try to start it several times . After the switch is normal, put it back into use. 完成以 后, 必须 通入介质试动作 次,确认正常后 投入正式使用。 After the installation of the stainless steel solenoid valve is completed , the medium must be tested a few times , and it is confirmed that it is normal before being put into use. 如果 不用,应将内部及零件 擦干净 并用压缩空气吹净贮存。 The stainless steel solenoid valve is removed from the pipeline. If not used, the interior and parts should be wiped clean and blown with compressed air for storage. When using for a long time, if the seal between the piston and the valve seat is not good, the piston sealing surface can be ground again, and then the valve seat can be ground.

Jiangsu Dongxiang Instrument Co., Ltd. main products: electromagnetic flowmeter , orifice flowmeter , v-cone flowmeter , turbine flowmeter, vortex flowmeter, Verabar flowmeter, precession vortex flowmeter , thermal resistance, thermocouple, dual Metal thermometer, pressure (differential) force transmitter, pressure gauge, pressure calibrator, calibration simulator, paperless recorder, intelligent RF admittance level meter , ultrasonic liquid ( level ) level gauge , radar level gauge , Magnetic flap level gauge, safety barrier, isolator and so on.